CNC rotary transfer machine
UFMF95
MENSI A.
MACHINE LAYOUT:
- Machine bed
- Table with horizontal axis
- Clamp-holder jaws
- Nr. 12 machining units
- Electrical cabinet
Machine bed:
The machine bed is made of welded and normalized steel. It is equipped with a slide for conveying the chips.
The machine is also equipped with tool cooling unit and automatic chip conveyor.
Table:
Table with horizontal axis with HIRT crown gear blocking system with 8 stations. The diameter measured from the centre of the jaw to the centre of the table is 950 mm.
The rotation cycle is the following:
- Table release
- HIRT crown gear release
- CNC controlled rotation with brushless motor and speed reducer
- Table locking on HIRT crown gear
Clamp-holder jaws:
The table is equipped with self-centring jaws with a number of clamps that are easily interchangeable.
The dimension of the centre of the clamp-holder spin is 100 mm.
The clamping of the piece is carried out by means of an oleo dynamic cylinder, that operates two levers located in the clamp-holder slide.
An oleo dynamic distributor on the axis of the table sees to the feeding of the single pistons.
On the loading-unloading station such distributor allows the automatic clamping and release of the jaw.
The working stations are protected by a safety device that does not allow the jaws to open in case of pressure drop.
The machining units have the following layout:
- No. 4 units on the right side
- No. 4 units on the left side
- No. 4 radial units
-
video
-
zoom
