Watch the video

Hydraulic die spotting press Millutensil
180 - 5000 kN

DESCRIPTION
The press BV or MIL is used for splitting, adjusting, maintenance and try-out operations on dies and moulds (thermoplastics, die casting, thermosetting, rubber and blanking) and it is possible to inject special waxes, at low pressure, into the mould.
CONSTRUCTION
The very sturdy structure consists of a welded and normalized steel basement and cast iron base-plate.
The lower plate is idraulically extensible and therefore it makes easier the carrying-out of the mould loading and unloading. Furthermore it makes possible to draw the die or mould lower part out of the press by carrying-out the treatments in effortless work position.
The upper plate slides vertically by hydraulic actuation on the four guide columns and can be overturned by 360° way it is possible to put the upper part of the die or mould upper part in effortless work position. The upper plate clamping in the exact horizontal positioning will be given by four hydraulic actuated locating pegs.
CONTROL PANEL
Each button on the control panel is marked with a clear function. The sequence of movements is controlled by PLC-SIEMENS S7 to prevent any mistake of the operator.
MACHINE CONTROLS
Pre-programmed SIEMENS S7- electronic controls.
ADVANTAGE
- Digital control of the parallelism
- Digital monitoring of stroke
- Digital monitoring and setting of pressure
- Self-learning system for recording of mould stroke
- Multi-languages diagnostic error search
- Management of all press functions