Three-phase servo-gearmotor MCDBS

brushlesswormright angle

BRUSHLESS SERVOMOTORS WITH NTEGRATED DRIVE AND WORM SCREW REDUCTION GEAR. EN: Brushless servomotors with integrated drive and worm screw reduction gear. Rated torque 9 Nm MOTOR: Brushless 4-pole three-phase sinusoidal motor, totally enclosed. Rotor with NdFeB magnets. Thermal cutoff. Winding Class F. Thermal cutoff. Protection IP65 in compliance with IEC/EN 60529 standards. Bearings with reduced backlash and special grease for high temperatures. DRIVE: Power 24 and/or 48 Vdc • Magnetic absolute encoder SSI (12bit single-turn / 16bit multi-turn) with internal buffer battery• 5 PNP digital inputs and 1 analogue input -10 +10V ext. (0-5 o 4-20mA optional) • 1 relay output (NC-NO) • USB port for parametrisation • Torque, speed, position and homing control. GEAR UNIT: with worm screw and die-cast aluminium gearcase. 26 mm centre distance. CARO bronze crown with a hardness of 120÷160 HB. The worm is made of tempered steel, with ground thread. . Seal rings in special high-temperature rubber (FKM). Lubrication with special long-lasting oil. There are 10 available gear ratios (i), from 5 to 80. Rated torque up to 9 Nm. Version B3 – B5 (B5/S left – B5/D right). All the models are implemented with the new “open” platform, which permits configuration with the following primary protocols: CanOpen, Ethercat, Modbus, Ethernet/IP, Profinet, Powerlink. N.B. To choose the right gear motor, please refer to the relevant charts for duty and maximum shaft load coefficients. These gear motors need to be run in. Therefore, for approximately the first 30 operating hours the torque will be lower than what indicated in the data.