Contactless Hall effect angle sensor
IP69K | TPS280DP
PENNY GILES CONTROLS
A new variant of the popular contactless rotary position sensor range, which uses a factory programmable non-contact Hall effect sensor system.
TPS280DP is designed as the modern alternative to rotary potentiometers fitted on high performance race car and motorcycle induction systems.
TPS280DP is mechanically interchangeable with most existing throttle potentiometers using 32mm mounting centers and is designed to interface with most common throttle body D type spindles. The sensor has a choice of 200 or 500mm cable lengths, with or without an MSS4P Mini Sure Seal connector fitted to the FDR-25 sheathed spec 55A cable. With sealing to IP69K, it is also able to withstand high pressure wash-downs.
The TPS280DP operates from 5Vdc (and 9-30Vdc) and is factory programmed to allow a wide range of configurations.
Key Features
> Electrically interchangeable with potentiometers
> More than 9x the life of a potentiometer
> Extremely low signal noise, for the life of the sensor
> Will operate from -40 to +140°C, with excursions to +170°C
> Sealed to withstand high pressure wash-downs (IP69K)
> Mechanically interchangeable with potentiometers on 32mm mountings
> Standard output is dual channel
> Configurable output direction, for left or right fitment
> Measurement range from 20 to 360° in 1° increments
> 12 bit resolution (0.025%) over the angular range
> Analog (0.5 - 4.5 or 0.1 - 4.9Vdc) or PWM outputs
> 2.5 or 0.15mS input/output delay
TPS280DP is designed as the modern alternative to rotary potentiometers fitted on high performance race car and motorcycle induction systems.
TPS280DP is mechanically interchangeable with most existing throttle potentiometers using 32mm mounting centers and is designed to interface with most common throttle body D type spindles. The sensor has a choice of 200 or 500mm cable lengths, with or without an MSS4P Mini Sure Seal connector fitted to the FDR-25 sheathed spec 55A cable. With sealing to IP69K, it is also able to withstand high pressure wash-downs.
The TPS280DP operates from 5Vdc (and 9-30Vdc) and is factory programmed to allow a wide range of configurations.
Key Features
> Electrically interchangeable with potentiometers
> More than 9x the life of a potentiometer
> Extremely low signal noise, for the life of the sensor
> Will operate from -40 to +140°C, with excursions to +170°C
> Sealed to withstand high pressure wash-downs (IP69K)
> Mechanically interchangeable with potentiometers on 32mm mountings
> Standard output is dual channel
> Configurable output direction, for left or right fitment
> Measurement range from 20 to 360° in 1° increments
> 12 bit resolution (0.025%) over the angular range
> Analog (0.5 - 4.5 or 0.1 - 4.9Vdc) or PWM outputs
> 2.5 or 0.15mS input/output delay
