Stepper motor controller PHYTRON

Drives catch the signal of a driver unit faster than a traditional power stage. Accordingly, they receive no tact or direction signals, but rather "higher quality commands" such as: Absolute position "goes to zero". Such commands can be stored and called up again by a control unit for example. The direct retrieval of commands over a PC or over an interface on the device is also possible.

Stepper Motor Drive with Power Supply Unit: GSP

High efficiency power stage and axis controller for 2-phase stepper motors
Power supply unit for direct connection to 230 VAC or 115 VAC
GSP 92-70: up to 9 APEAK / 70 V
GSP 172-140: up to 17 APEAK / 140 V
Processor controlled step resolution selection
Dynamically optimised switching from 1/8 step to full step
Digital I/O for direct connection e. g. to a PLC
Optional: CAN bus, SFI step failure indication
Design acc. to EMC standards and Low Voltage Directions
Control by PC or PLC

More specifications...