Hydraulic punching machine for tubes and profiles PRADA Nargesa SL

QUICK AND ADJUSTABLE NEW FEATURE HYDRAULIC DIE-CUTTING PRESS PI85
NEW DEVELOPMENTS IN THE LOCKSMITH'S MARKET
The PI85 hydraulic press is specifically designed for die-cutting tubes for the various cylinder locks available on the market, covering more than 90% of the models.
It permits the simultaneous cutting of the mechanism box hole with those for the latch and deadbolt. It is also possible to make the latch and deadbolt cuts independently in order to vary the distance between them.

The PI85 Incorporates a system with a scale In millimetres that controls the distance between the mechanism box and the latch and deadbolt from 18 to 37 mm approximately.
A distance between axles of 85 mm. Adjustable entrance points of 20, 25, 30, 35 mm.
MECHANISM BOX
Adjustable mechanism box length.
The mechanism box is always on the side and of 35,40,50 mm.
Approximate time taken to cut out the mechanism box slot is 58
seconds.

www.nargesa.com