DESCRIPTION:
The PSP 100 is a tool able to manage up to five controls simultaneously.
It is equipped with three entries reserved for controls of ejection, two entries reserved for the positional checking of band, an exit poiur the stopping of the press.

Principle:
The selection of controls corresponds to the sensors used. With each lathe of crankshaft of the press, the signals of the sensors are considered and put in memory. The cyclic probe (inductive detector provided with the controller actuated by a cam fixed at the crankshaft) makes it possible to question the memory and to stop the press in the event of absence of the one of the signals. The angular position of the cam (cyclic probe) takes as reference the last signal sensor because the PSP 100 has an entry cam. there is defect for the controller if all the signals of ejection or position did not appear before the cyclic signal probe.

Car training:
Controller PSP 100 functions by car-training. Initially to the installation of the apparatus, the PSP 100 will memorize in learning mode the configuration of production. Then, in production mode, it will compare automatically the cycle memorized with the successive cycles and will act in the event of defect.

FEATURES:
Tension: 220 V AC 50 Hz (110 V on request)
Entries sensors: 24 V PNP (NPN on request)
Cyclic probe: Provided M12 PNP
Cyclic probe esp necessary if the press is already equipped with an electronic cam (typeME 8C DIMECO)