wastewater pump / with electric motor / submersible / impeller
with electric motor
for machine tools, for the glass industry
feed, for used oil, cast iron, steel
Max.: 760 l/min (200.7708 us gal/min)
Min.: 30 l/min (7.9252 us gal/min)
35 m (114'09")
Max.: 6 kW (8.16 hp)
Min.: 4.8 kW (6.53 hp)
Submersible motor-driven pumps Type AP 100-112 closed impeller
They are suitable for transferring liquids containing impurities up to 2 mm in size.
Their hydraulic components: impeller and feed screw in cast iron, pump body in cast iron/steel allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel).
The temperature of the liquid must not exceed 90°C.
They are commonly used on:
- machine tools (milling and turning machines-machining centres)
- glass processing machinery
- surface treatment plants
- filtration systems
They are normally installed on a tank with a capacity which is proportional to their flow rate, about 6-7 cm from the bottom.
It is important to make sure that the maximum liquid level in the tank is always 3-4 cm lower than the support flange (see figure).
Should the liquid be particularly dirty, it is advisable to build a compartment tank in order to allow the sludge to deposit before it is sucked by the pump.
For different uses, please consult our Technical Office.