Mounted ball bearing unit for higt temperature
SealMaster
* Available as fixed (non-expansion) and float (expansion) unit arrangement to allow for shaft expansion.
* Heat Gard Ultra seals and end caps are standard on all units.
o HFC (Fixed) are open end caps to allow shaft to pass through to drive systems that come with V-ring end cap seal
o HEC (Float) are closed end caps designed for the non-drive side
* All units are supplied with standard set screws. A square head bolt is provided with the HEC cap for installation to allow the shaft to expand (float) along a keyway required in the shaft.
* The units are equipped with two pipe plugs inserted into two drilled and tapped holes in the casting located 180° from each other. This allows the user to remove the pipe plugs, add pipe extensions or lube lines in order to add additional lubricant to the top hole while purging (draining, forcing out) old lubricant out the bottom hole.
* Custom anti-rotation lock nut, which helps to prevent outer ring "creep".
* Wide outer ring design provides increased grease capacity to lubricate the bearings.
* Black oxide standard on inner/outer rings and seal components inhibits corrosion.
