Push-to-close latch 050-0150

steelstainless steelrotary

This two rotor latch is designed for medium to heavy-duty applications for off-highway entrance doors. It features an integrated linkage that allows for direct L-handle actuation and provides for ease of mounting and applications. Designed For Door thicknesses of 1-7/8" or greater (47.6mm) Door weights of 50-200 lbs. (23-91 kg) Door seal pressures of 50-150 lbs. (23-68 kg) (suggested for best results) Use with TriMark 070-0200 Striker Bolt Available In left or right hand configurations (right hand shown) With drive bar receiver parallel to striker bolt or rotated in 15° increments (as illustrated) Installation (4) 1/4-20 UNC grade 5 mounting fasteners (not included). Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 120 in-lbs. (13 N-m) Maximum .312" (7.9mm) diameter mounting holes Latch & Striker Installation Install striker bolt in door frame Close door carefully and check for interference between head of striker bolt and latch components Add or remove shims under striker bolt washer as required (outside diameter of shim should be larger than outside diameter of striker bolt washer) Adjust striker bolt vertically so door is not guided upward or downward while being closed CHECK TO DETERMINE THAT BOTH SECONDARY AND PRIMARY LATCHING POSITIONS ARE USABLE Door should be latched but not "closed" in secondary position and latched to anticipated "closed" position with respect to adjacent surfaces in primary position