Plastic granulator for injection molding
Baby series
Wanner Technik GmbH
The granulator type B08.10 is specially designed for the granulation of CD sprues, while the modell B08.10S is designed for general microinjection moulding applications .
The cutting chamber of the B Series granulators including rotor and screen are made of stainless steel, to fulfill also high purity standards for regrind. In addition, the cutting chamber is hermetically sealed to prevent the regrind from being contaminated by incoming air or dust when extracted by suction. It is therefore possible to use this granulator
under clean room conditions, as is typical in CD production.
Both models granulate sprues at low speed. This ensures a virtually dust-free regrind as well as maintaining a very low noise level.
The optimized geometry of the V-formation scissors cut and the cascading, multi-level rotor is providing a very effective granulation process and therefore the power required
by the geared motor is reduced without compromising granulator efficiency.
-
zoom
