Product concept Bevel gear units are favoured when unfavourable installation conditions necessitate a direction change in the transmission. The bevel gear sets have spiral toothing and are manufactured from alloy case-hardened steel. All gear unit housings are cuboid in shape, are machined on all sides and also have mounting holes on all six sides. Additionally there is a centring fit. Advantages and features 6 sizes from 88 to 260 mm edge length 4 standard transmission ratios from 1:1 to 4:1 Special transmission ratios upon request Drive torques up to 2,400 Nm Model range The gear units are available with a single sided or double sided drive shaft as well as with a hollow shaft. Gear units with additional, even three dimensional shaft branches are likewise available. Type W: Gear unit with free input shaft Type MW: Gear unit with motor flange and coupling for IEC motors Customer specific adjustments In many cases, gear units are also matched to the specific guidelines of individual requirements, e.g. as a servo version with low backlash toothing or as a stainless steel version for use in industries with stringent hygiene and cleaning guidelines (foodstuff, pharmaceutical and chemical industries). Further information can be obtained