|
|
|
|
|
|
Style 360 Repair Clamp
The Dresser® Style 360® repair clamp offers simplicity and ease of installation. Just wrap the clamp around the pipe, drop the bolts in place and tighten. It's that simple! Moreover, special one-inch long nuts allow the use of a standard deep socket wrench for complete tightening. In the popular 7.5 inch clamp width, there is also a third nut so
the middle nut can be used to pre-tighten the clamp.
Additionally, the smaller sized clamps feature a flexible band which means less holding force is required while tightening.
With the "360" clamp you can repair holes, breaks and splits in the pipeline. You can use it where pipe ends are separated, or where ends are deflected up to 4 degrees or 1/8 inch. Or you can join two pipes with a variation of 1/4 inch outside diameter.
Clamp features include a tapered gasket with a gridded design and the spanner is molded flush with the gasket to prevent "hang up." The "360" has a stainless band, lugs of rugged ductile iron and bolts of corrosion-resistant Dresserloy.
|
|
Style 194 Service Saddle
For use on PVC Pipe (IPS, OD)
Offers 360-degree support for taps off plastic mains
Designed with plastic pipe in mind, the Style 194 service saddle provides a low cost efficient means for supporting the pipe where service taps are made.
Check these advantages:
- Simply "wraps" around the pipe. One bolt to tighten.
- Full 360-degree support of the pipe, with designed-in safeguard against overtightening. Cannot deform the pipe.
- Recessed rubber compound gasket is confined, cannot blow-out, or cold-flow to weaken the seal.
- Boss furnished with either corporation or IPT threads, to suit your standards. 3/4" and 1" tap sizes available.
- Rugged malleable iron bodies are galvanized for long service life. Bolt is corrosion-resistant Dresserloy, cadmium plated.
|
|
| ... products without technical information |
| |
 see the results for the following category : Hose clamps |
|
|
