MPPT charge controller DuoRacer Series

batterysolarModbus

DuoRacer MPPT charge controller is made for charging two batteries (shown as BATT1 and BATT2 below) at the same timein a solar system. This controller supports multiple life battery (BATT1) types, including Sealed, Gel, Flooded, LiFePO4, andLi-NiCoMn, which is suitable for RV, Camper, Boat, and so on. The device recognizes the start battery (BATT2) system voltageautomatically, and trickle charges the battery when the conditions are satisfied.The controller adopts the advanced MPPT control algorithm,which will minimize the maximum power point loss rate and losstime,also fast track the maximum power point(MPP) of the PV array, and obtain the maximum energy from solar array underany conditions. The energy utilization in the MPPT solar system is increased by 20-30% compared with PWM charging method.When there is no manual operation for a long time, and the charging conditions cannot be reached, the controller will turn tolow-power mode, which reduces the loss and battery power waste to enhance the products life. The system parameters areshown and set by LED/LCD or the MT11 remote meter (Accessory).The AES control signal of the car refrigerator is built in the controller, which will supply the surplus solar power to the refrigeratorto avoid energy waste. The controller comes with IP33 protection level, which is waterproof and dustproof. Multiple protectionfeatures, including battery overcharge protection, over discharge protection, and reverse connection protection of the PV andbattery, which effectively ensure the solar system safety, stability, and lifetime.