Inground lifts with drive surfaces are especially suitable for direct receiving and the repair area - and, with optional wheel alignment kit, also for wheel alignment. All models can be retrofitted with a jacking beam. The DP comes standard equipped with a jacking beam built into the drive surface.
Integrated drive-on diagonals are used instead of the normal drive-on flaps, which hang down and interfere during start-up. Travel is fast, easy and produces no rattling noise.
Dye cast aluminium balance plates (MP models only), adjustable longitudinally or longitudinally and perpendicular to the direction of approach ensure comfortable and reliable vehicle support. They provide an enormous range of support while occupying a minimum amount of floor space.
4 lights are built into each of the two tracks on the inside. They are turned on and off automatically as the tracks are raised or lowered.
Installation cassette with stainless steel cover and built-in rubber face seal.
Short assembly times thanks to lift unit preassembled in the factory with 12-m long cable set.
The drive rails are hot galvanised and/or powder-coated and are additionally fitted with an aluminium chequer sheet plating.
While lifting the track mounted at floor level, the optional automatic ground level compensation system closes the recess in the floor with 4 small after-stroke cylinders.This combines the advantages of installation at floor level (no drive over height) and the version resting on the floor (area under the vehicle is completely accessible without any difference in level).
Base guides made of high-tensile stainless dye cast aluminium alloy with built-in seal, guide belts, and grease chamber.