Hybrid connector

Ethernetbayonetshielded

CONEC Hybrid connectors soon to be certified according to IEC standard 61076-2-118. For conventional wiring of motors, servo-drives or linear units/drives, time and costs for cabling, maintenance and diagnostics are very high. Separate cables from the switch cabinet are used for the power supply and control of every single motor. This procedure does not only require much space, but also causes high costs. With the new CONEC series, a compact hybrid connector system has been developed, combining power supply and data transmission in one single connector. This technology is equivalent to the modern connection and interface wiring technology. Depending on the application, four sizes, B12, B17, B23 and B40, are available. While the number of pins and the permitted voltages vary depending on the size, the 360° shielded data core is always the same and designed for industrial ethernet Cat 5 with wire cross section AWG22. CONEC presents this hybrid connector system in the form of connectors with overmoulded cable, field attachable connectors as well as receptacles for device-side installation. Each pin layout is available with min. 2 different codings - optically marked by different colour rings. Thus, misplugging is impossible in different applications. Sockets are available in various housing variants for front- and back panel mounting and the installation heights vary on the outside or the inside of the housing. Thus, decentralized wiring chains can be realized with and without Daisy Chain topology with a cost saving one-cable solution.