Cranes fitted with a special base for easy fixed installation on any type of vessel, central controls and distributor separate from the structure, protected from salt water.
MARINE ENVIRONMENT PAINTWORK
Treatment of the marine series cranes consists of the following cycle: grade A Sa 2 ½ sandblasting (standard ISO 8501-1); organic epoxy zinc plating application (minimum thickness 70µm); intermediate layer with spray application of two coats of bi-component epoxy primer (thickness 100 µm) and a final dual layer of bi-component polyurethane glaze (thickness 70 µm) with average total thickness of the dry film on the entire packet of 240 µm. In this way a very high resistance to corrosion of up to 1500h in the salt fog testing is ensured according to the standard ASTM B117 (UNI ISO 9227).
ADDED PROTECTION
The main and secondary jack rods have a tempered chemical nickel plating (50 micron) and chrome plating (100 micron); the extension jack rods and rotation cylinders have a double chrome plating. Protection is completed by application of “dinitrol” on hollow internal surfaces, and double nickel coating of stainless steel pins, screws and clamps.
HIGH EFFICIENCY
The latest innovation of the development of a base with a double rack makes it possible to double the slewing torque, without increasing slewing pressure. This results in an improvement of performance when the crane is at an angle, as is often the case out on the water. Cranes fitted with this system are in fact capable of exceeding the 5-degree inclination limit and of handling loads in rotation up to approximately 10°.