● Analog output 4..20 mA or 0..10 V
● Two programmable switches (push-pull)
● Backlit graphical LCD-Display (transreflective), can be read in sunlight and in the dark
● Programmable parameters via rotatable, removable ring (programming protection)
● Full metal housing with non-scratch, chemically resistant glass
● Physical unit in the display (selectable)
● Rotatable electronic head for best reading position
● Tropical model optionally available
● High temperature model (200 °C) optionally available
● Connection to USB interface for setting parameters
The primary sensor consists of a platinum resistance sensor using thin film technology, which provides a very good response time, thanks to the lance diameter of 4 mm.
With these sensors, switching points can be set on the spot for where process values are exceeded or fallen short of. This setting can be carried out via the display, even without the process. The present values, or error messages from the measuring point, are visible at all times, and all important parameters can be displayed locally (this saves time during installation, commissioning, and troubleshooting during the process). The analog current signal can be evaluated from large distances, and the present values can be made available there. The sensor is configured to your requirements. It is therefore ready for immediate use, without programming. If you wish to change parameters, you can set the device directly at the sensor, by means of the programming ring.
The entire family of OMNI sensors is made up in a modular way, by means of a building-block system (hardware and software).