The tungsten carbide deburring tools from Mikron Tool reach top-level performance when it comes to chamfering and deburring in small dimensions, difficult materials and hard-to-reach locations. CrazyMill Frontchamfer in the diameter range of 1.0 mm to 6.0 mm (.0393" to .236") reaches even difficult-to-access locations because of its ingenious geometry and exhibits a constant, positive cutting behavior over the entire cutting edge. CrazyMill Backchamfer in diameters of 0.36 mm to 5.7 mm (.0142" to .224") for back edge deburring or hole deburring even in the smallest dimensions without unclamping the part (alternative process to thermal deburring). With CrazyMill Doublechamfer in the diameters of 0.9 mm to 5.7 mm (.0354" to .224") you can deburr edges and difficult-to-access locations front and rear with one single tool.
CrazyMill Doublechamfer combines the possibilities and qualities of both prior tools. It can deburr front and back in a single clamping. Its small diameter (available from diameters of 0.9 mm/.0354" and up) allow the back deburring of holes from a diameter of 1 mm (.0393"). Depending on the application the user can choose between a long version with a usable length of up to 6 x d and a short version with a usable length of up to 3 x d. The latter gives the tool even greater stability and is especially suitable when it comes to smaller edge widths or shorter drilling depths. The following applies here as well: The high number of cutting edges (4 – 6 depending on diameter) provides for excellent surface quality.