Remote control unit KN-LIN series

Designed for remote control of VS-5 signaling devices and switching units BK via power and signal line of “SENS ” Measurement System and provide: using KN-LIN-VS button (push-button): a) turn off VS-5 signal; b) do periodical check of VS-5 signaling devices operational capability VS-5; using KN-LIN-BK button (push-to-lock button) - control single or multiple BK, BPK units. Design, principle of operation Design: Housing of KN-LIN-VS (fig. 1) and KN-LIN-BK (fig. 2) is made of shock-proof polystyrene. VUUK-2KV-KN-LIN-VS (fig. 3) has the same functions as KN-LIN-VS buttong but has a housing made of 09Mn2Si steel. The buttons are connected to SENS power and signal line using 3-wired cable. The buttons have 2 cable entries to provide transit connection to line. Principle of operation: KN-LIN-VS device with push-button works as follows: short pressing of button turns off triggered VS-5 signaling devices; long pressing of buttons turns on VS-5 signaling devices. KN-LIN-BK device with push-to-lock buttons works as follows: when button is released (LED is off) - “normal” signals are supplied to the line, that do not change state of secondary devices; button is pressed (LED is one) - triggering signals for secondary devices are sent to power and signal line (signals of reaching of critical units): switching of BK units relays, turning-on of VS-5 signaling devices. Note: Buttons are the “sensors”in SENS Measurement System. Failure monitoring: triggering of VS signaling devices and BK relay units occurs in case of button connection failure. Settings made during buttons configuration: addresses of BK units relays VS-5 signaling devices; signaling duration.