cup anemometer / with analog output
ANTC V2.2 INOX

{{requestButtons}}

Characteristics

  • Technology:

    cup

  • Other characteristics:

    with analog output

Description

ANTC_V2.2_R is an anemometer, which meets every requirement of use
in electronics. Is in fact equipped with its own programmable logic. It can be
used for any on-board detection of wind turbines in the presence of sources
of power from batteries 24 vdc.
Its output signal can be configured for pulse output, voltage output 0-5 / 1-
5 / 0-10 / 2-10 Vdc, current output 0-20 / 4-20 mA.
It can be connected through the various outputs available depending on the
model directly to PLC and / or board electronic market, tachometers
WM44P as the model of our product range.
The body of the rotor is machined STAINLESS STEEL AISI316. The head
rotates on ball bearings. The cups are made of nylon shock-absorbent and
easily interchangeable. It also features a convenient connector for
connection.
The count rate is via optical transducer, a digital encoder with 12 pulses per
revolution.
Complete of anti-icing HEATER
It is produced in the following versions:
 Impulsive Frequency output (Hz)
 Analogic Voltage output 0-5 / 0-10 Vdc
 Analogic Voltage output 1-5 / 2-10 Vdc
 Analogic Current output 0-20 / 4-20 mA
Each anemometer is equipped with Nylon Cups interchangeable, stainless
steel support, 5 pin M12 screw jack connector.
EACH TRANSDUCER IS TESTED IN A WIND TUNNEL AND EQUIPPED WITH A
CALIBRATION CERTIFICATE.
It runs on request, a periodic calibration and calibration product.