Air-drying bonded coating on MoS₂ basis for dry lubrication of machine elements at temporary operation and long standstill periods.
Areas of application
Run-in lubrication in combination with oil or grease lubrication
Dry lubrication at sliding pairs, in particular under heavy loads and low sliding speeds, at oscillating movements or intermittent operation
Dry lubrication at high operating temperatures (up to 450°C), shorter sliding paths and low speeds
Dry lubrication in dusty environment, to avoid adhesions
Coating of punching tools
Advantages and benefits
Highly effective due to good adhesion to prepared substrates
Allows a low coefficient of sliding friction also under heavy loading
Increased wear protection
Radiation and vacuum-resistant
Shortens and improves run-in conditions of friction bearings, toothings and other sliding pairs
Operating temperature: -180 °C → +450 °C
Press-fit: µ = 0.07, no stick-slip
For best adhesion, clean the surfaces mechanically first and then with OKS 2610/OKS 2611 universal cleaner. The surfaces to be treated must be bright metal and dry, surface roughnesses of 5-10 μm have proved to be favourable. Chemical or mechanical pre-treatment of surfaces may extend the service life of the non-stick paint. Stir the paint thoroughly before use. At OKS 510 apply in an evenly thin film to the prepared surfaces, preferably by spraying or dipping, in individual cases also by brush. Spray on evenly OKS 511 spray. Avoid excesses. Drying and curing conditions as per the following technical data.
No matter what industry you come from, we at OKS have the right solution for you.