Type 1 surge protection unit SP2 series

type 2outdooranti-surge

Eaton's SP2 is a compact surge protective device with a 45KA per phase footprint and one-inch molded nipple that makes this device easy to install on point of use locations, control panels, load centers and small distribution panels (up to 200amp). With a 10KA nominal discharge rating (ln), low VPR ratings and a 200KA SCCR rating, Eaton's SP2 series surge protective device are ideal for type 1 and 2 applications where dependable performance is required. Made for any environment A compact UV-resistant NEMA 4x enclosure means this surge protection device can be using in indoor or outdoor applications Visually access the health of your protection An LED status indicator provides surge protection status at-a-glance with a green indicator light. Mounting options for any application The SP2’s compact footprint, half-inch molded nipple and optional din rail mounting kit make this surge protection device easy to install anywhere you need it. MARKETS Light commercial and UL 508A panels SYSTEM TYPES Split-phase INSTALLATION two-, three-, four-wire MAXIMUM CONTINUOUS OPERATING AC VOLTAGE Matched to nominal voltage PROTECTION Surges and transients SCCR 200 kA NOMINAL DISCHARGE CURRENT 10 kA MAXIMUM DISCHARGE CURRENT 45 kA RESPONSE TIME <25 ns FREQUENCY 50/60 Hz OPERATING STATUS/FAULT INDICATION One bi-color LED (green: good, red: replace) CONDUCTOR GAUGE/LENGTH 10 AWG stranded copper/ 18 inches MOUNTING Chase nipple/bracket ENCLOSURE RATING NEMA 4X UL 94-5VA DEGREE OF PROTECTION (INSTALLED STATE) IP20 (finger-safe) INSTALLATION LOCATION Indoor/Outdoor CIRCUIT LOCATION Lineside/Loadside STANDARDS/AGENCY INFORMATION UL 1449 3rd edition Type 1 listed SPD cULus