Braking resistor BRW series
wire-woundLVhoused

braking resistor
braking resistor
Add to favorites
Compare this product
 

Characteristics

Technology
wire-wound
Electrical characteristics
LV
Mounting
housed, ceramic-housed
Applications
braking
Other characteristics
air cooled
Resistance

Max.: 5,000 Ohm

Min.: 0.12 Ohm

Power rating

Max.: 10,000 W

Min.: 15 W

Description

The dynamic braking resistor kits were designed for stopping a motor at full load current from base speed with 6 times motor energy, four stops per hour (NEMA ICS 3-301.62 Dynamic Braking Stop Option). AC Drives(Variable Frequency Drives) use dynamic braking resistors to dissipate excess energy from the DC bus caused by fast stopping or high supply voltages. This can be required even when the drive is stopped so the resistors operate, more-or-less, continuously. The drive must be ordered with a braking module installed to use dynamic braking resistors. These reactors are intended for use with the 690+ series three-phase controllers. They may be used when voltage transformation or supply isolation is not required. Consult factory for resistors for older products. Features: Applications: Elevator, port machinery, rolling mills, hoist the generator, inverter and other brake and load Use of the environment: Rated temperature (+70 ℃); use with the temperature range (-55 ℃ ~ +375 ℃) Structure: rated power temperature (+70 ℃); use with the temperature range (-55 ℃ ~ +375 ℃) Applicable standards: GB/T5729-2003 GB5732-85

Catalogs

No catalogs are available for this product.

See all of VTDRIVssE Technology Limited‘s catalogs
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.