DC gear-motor / worm / coaxial / 50 W...100 W
50 W...100 W, 100 W...500 W
5 - 10 Nm, 10 - 20 Nm
BMS7152-50 is a complete set, included DC motor controller BMSD and a DC brush gearmotor SM7152W with worm gearhead 1/50. The drive is reversible, gearhead is self-impeding. Two side output shaft is turned through an angle of 90° relative to the motor shaft. Motion control via RS-485 is provided.
The BMSD controller, included to the complete drive, adjust motion speed, direction, acceleration and deceleration. The motion control provided by input signals or by commands via RS-485 interface.
Motor speed is adjusted by analog voltage signal 0-5VDC, by potentiometer - internal (there is a built-in potentiometer on the case of the BMSD controller) or external (can be connected to the controller) or by a command via RS-485. Start/stop and direction are digital signals, also can be controlled via RS-485. The inputs are duplicated by buttons on the controller's case. Inputs (and buttons) handle a signals as per the front edge or signal level. The version depends on a controller firmware - please, ask when order.