in-line conductivity meter
WEC, WDEC410 series

Add to MyDirectIndustry favorites
Compare this product
in-line conductivity meter in-line conductivity meter - WEC, WDEC410 series


  • Type:



The WEC/WDEC410 Series Single and Dual Input Electrodeless Conductivity Controllers measure conductivity of a solution via an encapsulated, non-contacting sensor to control replenishment pumps and alarms.

They may be installed in a variety of very harsh chemical control applications, including oily cleaner baths, chromates, rinse tanks, fume scrubbers and other concentrated chemicals up to a conductivity of 1000 mS/cm.

Four conductivity ranges may be selected to configure the controller over a wide
range of applications

PEEK sensors for higher temperature, more aggressive chemical applications, or CPVC sensors for lower temperature, less aggressive chemical applications
Both available for in-line or submersible applications

Single or Dual Input
One unit monitors two baths with control and alarm relay for each

Time proportional and control option selectable on front panel keypad
Varies the pump or valve on time depending on deviation from set point

Monitor performance without taking the unit off-line, permitting faster troubleshooting and less downtime

USB Flashstick Support standard for data logs, event/relay and reset logs, and user configuration file import/export

Choice of measurement units in μS/cm, mS/cm, ppm or % concentration
% Concentration allows the user to enter up to 5 calibration data points