Hardens and dustproofs weak, dusty concrete
Dustproofs and strengthens
One coat usually enough
Highly penetrating micronized acrylic
Rapid application using a broom
A colourless liquid resin which penetrates deep into concrete or other porous materials to provide a dust proofed, hardened surface. Watco Universal Sealer Dustproofer strengthens weak, dusty screeds and poor quality concrete. It also reduces porosity and dusting on brick, blockwork and plaster walls.
Recommended areas of use
Ideal for previously untreated concrete and masonry surfaces
Use on floors and walls, in factories, warehouses, machine shops
Suitable for treating cement screeds, porous tiles, brickwork, blockwork and plaster
Features
Suitable for a wide range of porous surfaces
Low solvent content and virtually odourless
Very easy to apply
Micro porous – allows substrate to breathe
Watco Universal Sealer Dustproofer is easily applied to new or old concrete surfaces using a soft broom.
Application
Surface preparation
A minimum of preparation is required; a good sweep to remove surface dust and dirt is often sufficient. The surface must be dry and porous to allow the Universal Sealer Dustproofer to penetrate. Oil and grease can be removed using Watco Bio D (or similar degreasant), the floor must then be rinsed with water and allowed to dry. If there is doubt that the subtrate is absorbent, pour some water onto the surface. If the water is easily absorbed, the surface is suitable for treating with Watco Universal Sealer Dustproofer. New concrete should not be treated until the surface is sufficiently dry to absorb the solutions (usually at least 7 days in good drying conditions).