Analog transducer 29441374

Switch point and advance interval setting and adjustment of switch output and analog output products Switch value and analog output can be set using the adjustment terminal, specifically, there are 8 working modes that can be set. The specific setting method of each type of bean flour is the following steps. In the first step, the user selects a distance set by himself, or puts the sensor into a lost wave state. The second part, connect the calibration terminal to the power supply or GND, keep it connected until the yellow light flashes (if the wave is lost, the red light flashes). In the third step, the user selects the second distance set by himself, or lets the sensor enter the lost wave state. The fourth step, connect the calibration terminal to GND or power supply (the state is different from the second step), keep it connected until the yellow light flashes (if the wave is lost, the red light flashes). There are 8 working modes of switch output 1. Window normally open mode (analog output products are in positive linear working mode or distance measurement mode). 2. Window normally closed mode (analog output product is in negative linear working mode or liquid level measurement mode). 3. Single point normally open mode. 4. Single point normally closed mode. 5. Single-point normally open mode with large hysteresis interval. 6. Single point normally closed with large hysteresis interval mode. 7. Whether to detect the normally open mode. 8. Whether to detect normally closed mode.