BERNSTEIN control foot switches
These basic enclosures are of similar dimensions except for its width that come in the variance of one, two and three pedals.
... withstands a drop of 20 kg from a height of 1 m. The foot switch is uniquely designed to allow inclusion of additional equipment: - Emergency Stop button - Contactor on DIN rail as main power ...
This is a cast aluminum protective shroud, which is suitable for various applications in the industry. The way this device works is by preventing the operation of the pedals until the shroud has been raised. Protection against falling ...
These foot switches come with significant protection and remain clean and dust free. They can work with sustenance against partial submersion in water. The model with IP 68 protection degree can be obtained on request. ...
... feedback). The pressure point applies when using two contact elements with differently adjusted forward travel (two-stage switch) Pedal pressed up to pressure point: Switching position for first contact element ...
After initially pressing the pedal, the switch setting is retained even after the pedal is released. The contact is not interrupted before the pedal is pressed again (bistable).
The sturdy tread face is covered with ribbed rubber and allows actuation of the foot switch with reduced operator fatigue due to its angle. It is equipped with six rubber feet to prevent slipping.
The pedal cannot be operated before the locking lever is released by the foot. This prevents inadvertent actuation of the pedals even in the event of strong vibration / shaking caused by incorrect handling.
... provide protection against inadvertent pedal operation. The pedal cannot be operated before raising the protective guard with the foot.
Foot switches with Power contactor LS combine an auxiliary power switch with a main power switch. Thus, the control of an engine can be realised without the need for ...
Your suggestions for improvement:
Receive updates on this section every two weeks.