- Power Transmission - Mechanical components >
- Mechanical Transmission >
- Rigid coupling >
- Cross & Morse
Cross & Morse rigid couplings
The Taper bushes represent a simple and cost effective solution for securing a connection between sprockets, pulleys and couplings to a variety shafts with metric and imperial dimensions, and general commercial tolerances ...
Torque: 784 Nm - 2,270,000 Nm
These shaft clamping elements provide maximum torque transmission from a single unit, but, due to their large clamping surfaces clamping pressures are kept to reasonable levels. The design enables automatic centring between shaft and ...
Torque: 350 Nm - 193,200 Nm
These shaft clamping elements are very compact units capable of transmitting medium torques. Their design ensures good concentricity between hubs and shafts, without any other means of location. A slight axial movement between hub and ...
Torque: 282 Nm - 2,700 Nm
Designed for use with standardised ranges of pulleys, sprockets, and gears, the shaft clamping elements can accommodate a large range of shaft diameters with a hub of constant bore diameter. On clamping precise axial and radial positioning ...
Torque: 264 Nm - 136,500 Nm
These clamping elements are basically to same design as RCK 13, but with increased diameter flange to locate hub and prevent axial movements, so combining good concentricity with positive axial location. The increase in friction between ...
Torque: 170 Nm - 1,943,000 Nm
Type RCK 19 are normally referred to as Clamping Discs, used to clamp externally onto thin walled hubs to lock them to the shaft. The design permits the use of large diameter shafts with small hub sizes, and is popular for connection ...
Torque: 250 Nm - 2,230,000 Nm
These are the original type of shaft clamping elements, proven in a wide range of applications for more than 20 years. Suited to more general applications, this series provides medium torque transmission, which can be increased by mounting ...
Torque: 403 Nm - 68,000 Nm
These shaft clamping elements are designed to give optimum concentricity, both radically and axially. Similar in design to the RCK 13, but with increased length to provide improved support, and reduced pressures on both shaft and hub. ...
Torque: 294 Nm - 48,200 Nm
The RCK 71 is a type RCK 70 with addition of a distance ring to prevent axial movement of the hub during clamping. Due to the additional friction between the element and hub during clamping maximum torques are reduced, but with reduction ...
Torque: 12 Nm - 29,041 Nm
Available for shaft diameters down to 6mm, these shaft clamping elements are designed to fit into small diameter hubs, being particularly suited to light duty, light torque applications. A spacer ring prevents axial movement during cramping; ...
Your suggestions for improvement:
Receive updates on this section every two weeks.