|
|
The Primefire 400 burner represents
an evolution in burner design. The Primefire 400 is designed to
significantly reduce fuel consumption
and NOx emissions over comparable
burners, while fitting into existing
control schemes.
The Primefire 400 burner achieves
these improved results by using a
form of gas pre-heating. By injecting
a small amount of oxygen into the
gas stream prior to the main combustion
process, the gas will actually
begin to "crack", releasing greater
amounts of carbon. This carbon,
which is consumed in the main combustion
process, increases the luminosity
of the flame. Since luminosity
has a tremendous impact on heat
transfer, the burner considerably
improves heat transfer and fuel
efficiency. Primefire Series 400 oxygen-fuel burners are available in four sizes with maximum capacities of 2MM, 4MM, 10MM and 20MM Btu/hr. All models are capable of 4:1 turndown and can be fired using natural gas or fuel oil.
|
|
OXY-THERM® Natural Gas Burners eliminate the need for costly combustion air pre-heaters, regenerators or recuperators and provide clean combustion with low NOx levels. OXY-THERM® Gas Burners use oxygen for the combustion reaction, removing atmospheric nitrogen as a source for NOx creation. OXY-THERM® burns any gaseous fuel or oil including low BTU off gases and waste oils. No other oxy industrial burner has as many installations or as much proven time in reliable production.
|
|
STAROX: burners oxy-fuels. They are burners with mixture at the flash point: the gas and oxygen become a combustible mixture outside the burner. They thus require neither to be cooled nor of ceramic parts.
Characteristics:
- Higher temperature with 1400°C
- Mixture at the flash point
- No water cooling
- Great flexibility in use
- Perfect stability of the face of flame
- Broad range of power
- Manufacture out of heat-resisting steel
Power:
from 50 to 500 kw
Applications:
Foundry
Metallurgy - Foundry
Metallurgy - Smelter
Glassmaking - Smelter
|
|
|
|
