Cutting edge counterbores

Diameter : 6.3 mm - 20.5 mm
Length: 145 mm

... costs. The newly developed ULTIMATECUT countersink 4S works with four instead of three cutting edges. The distribution of the forces acting on the four cutting edges ...

Diameter : 6.3 mm - 25 mm
Length: 145 mm

... costs. The newly developed ULTIMATECUT countersink 4S works with four instead of three cutting edges. The distribution of the forces acting on the four cutting edges ...

Diameter : 6.3 mm - 20.5 mm

... and thus has a higher cutting edge stability. Best results in VA steels, Hardox 400 steels, titanium and titanium alloys. Technical data Number of cutting edges ...

Diameter : 6.3 mm - 25 mm
Length: 45 mm - 71 mm

... CBN deep-ground flutes the cutting edges are extremely sharp. Ideal for burr- and chatter-free deburring and countersinking. Best results at low cutting speeds. Net weight 0.028 kg Technical ...

Diameter : 10.4 mm - 20.5 mm
Length: 50 mm - 80 mm

... costs. The newly developed ULTIMATECUT countersink 4S works with four instead of three cutting edges. The distribution of the forces acting on the four cutting edges ...

Diameter : 10.4 mm
Length: 50 mm - 80 mm

... costs. The newly developed ULTIMATECUT countersink 4S works with four instead of three cutting edges. The distribution of the forces acting on the four cutting edges ...

Diameter : 10 mm - 25 mm
Length: 80 mm - 120 mm

to produce counterbores for Cap screws, Hex Screwheads, Ejectors, spot facing, Gasket-seats etc. straight shank with «Weldon» flats, to DIN 1835B Also called countersinks, they have a straight cutting ...