Flow-control relief valves

DN: 0.5 in - 0.75 in
Pressure: 13.8, 10.3, 4.8 bar
Weight: 0.6, 0.4 kg

... heat actuated trap valve) is designed to monitor, control, and regulate flow, utilizing a temperature control actuator to constantly sense in-line fluid temperature. Since it is what ...

Controlled pressure: 207 bar
Flow rate: 34 l/min

... Adjustment may be locked in place. · Adjustment will not screw out of the valve body Operation In its steady state,the valve blocks flow at ① ,while allowing flow to pass ...

Controlled pressure: 350 bar
Flow rate: 60 l/min

... has exceeded the valve setting. Additionally, these Valve incorporate an integral check valve to provide reverse flow from port 2 (sequence) to port 1 (inlet). The ...

Controlled pressure: 350 bar
Flow rate: 60 l/min

... · Although this is a zero pilot flow valve, port 3 (drain) must be connected to maintain a pressure reference in the control chamber. If port 3 is blocked, reciprocating seal weepage ...

Controlled pressure: 350 bar
Flow rate: 120 l/min

... system, pump flow must be shut off for the valve to reset. Operation Kick-down sequence Valve will kick completely open and remain open once the pressure at the inlet (port 1) exceeds the valve ...

Controlled pressure: 350 bar
Flow rate: 28 l/min

... setting of the valve. Because of this, port 3 may not be usable as a work port in circuit. If this is a consideration, the 4 port version of this valve may be a solution · Because using direct-acting ...

Controlled pressure: 350 bar
Flow rate: 60 l/min

... sequence Valve with reverse- flow check will supply a secondary circuit with flow once the pressure at the inlet (port 1) has exceeded the valve setting. Additionally, these Valve ...