Heating strips

31 companies | 63 products
{{#pushedProductsPlacement4.length}} {{#each pushedProductsPlacement4}}
{{product.defLight}}
{{#if product.activeRequestButton}}
{{/if}}
{{product.productLabel}}
{{product.model}}

{{#each product.specData:i}} {{name}}: {{value}} {{#i!=(product.specData.length-1)}}
{{/end}} {{/each}}

{{{product.idpText}}}

{{productPushLabel}}
{{#if product.newProduct}}
{{/if}} {{#if product.hasVideo}}
{{/if}}
{{/each}} {{/pushedProductsPlacement4.length}}
{{#pushedProductsPlacement5.length}} {{#each pushedProductsPlacement5}}
{{product.defLight}}
{{#if product.activeRequestButton}}
{{/if}}
{{product.productLabel}}
{{product.model}}

{{#each product.specData:i}} {{name}}: {{value}} {{#i!=(product.specData.length-1)}}
{{/end}} {{/each}}

{{{product.idpText}}}

{{productPushLabel}}
{{#if product.newProduct}}
{{/if}} {{#if product.hasVideo}}
{{/if}}
{{/each}} {{/pushedProductsPlacement5.length}}
heating strip / silicone rubber / adhesive / with thermostat
heating strip

Maximum temperature: 1,120 °C

... aluminum mounting plate. A thermostat can be attached to the heater or mounted separately. Pictured are enclosure heater units with thermostat on heater in foreground and heater ...

See the other products
Watlow
heating strip / finned / nickel
heating strip
375 series

Maximum temperature: 1,120 °C

Watlow's 375 finned strip heaters are constructed of highly-compacted MgO-based insulation, which conducts heat efficiently from the nickel chromium element wire to the sheath. Two-inch wide (51 mm) aluminized ...

See the other products
Watlow
heating strip / ceramic
heating strip
ULTRAMIC® series

Maximum temperature: 400 °C

... ULTRAMIC® ceramic heaters from Watlow® are designed for thermal applications where the high performance of an advanced ceramic heater is required to ensure optimal effectiveness of the equipment and process. ULTRAMIC ...

See the other products
Watlow
heating strip / finned / ceramic
heating strip
FSH series

Maximum temperature: 149 °C - 600 °C
Power: 400 W - 2,500 W

The GBP 41.00 from Omega's Ceramic Insulated Finned Strip Heaters series is engineered with ceramic and magnesium oxide to provide optimum performance in extreme thermal conditions, with a tolerance length ...

See the other products
OMEGA
heating strip / ceramic
heating strip
HCS series

Maximum temperature: 649 °C
Power: 150 W - 2,500 W

The HCS series of strip heaters has been insulated with ceramic. They offer reliable services that deal with a maximum of 649 °C of temperature. These ceramic insulated strip heaters ...

See the other products
OMEGA
heating strip
heating strip
A series

Maximum temperature: 1,200 °F
Power: 125 W - 1,800 W

... insulated type of construction. It can provide more dependable, rugged and the longer term service. The usage of the ring heaters can be simplified with it's circular shapes and utility clamps. Rings can be nested for ...

See the other products
OMEGA
ceramic heating element / flat
ceramic heating element
CB series

Maximum temperature: 705 °C
Power: 40 W - 250 W

... Desoldering Equipment, Valve Heaters. Features •The Backer Hotwatt Ceramic Heater is a ceramic body encasing a resistance element and packed within magnesium oxide. •The heaters are terminated with ...

See the other products
Backer Hotwatt Inc
heating strip / ceramic
heating strip

Maximum temperature: 1,200 °F
Power: 50 W - 4,320 W

... Stainless Steel Strip Heater provides clean, dependable heat with sheath temperatures up to 1200°F and watt densities up to 40 watts per square inch. •Because of the seamless stainless steel sheath, ...

See the other products
Backer Hotwatt Inc
heating strip / finned / ceramic
heating strip
FS series

Maximum temperature: 300 °F - 600 °F
Power: 50 W - 4,320 W

Description U.L. Recognized – E56973 C.S.A. Certified – 016386-0-000 Finned Strip Heaters: In-Stock Applications Air Heating, Air Ovens, Load Banks Construction 1.Seamless stainless steel ...

See the other products
Backer Hotwatt Inc
heating strip / finned
heating strip

Maximum temperature: 500 °F
Power: 125 W - 1,500 W

... in tubular heating elements that allow for effective heat transfer. Finned strip heaters are a fairly inexpensive way of heating small areas and are an excellent solution ...

aluminum heating element / flat
aluminum heating element
HAP

Maximum temperature: 250 °C
Power: 10 kW

Applications Heating of parts and moulds, wood and paper industry, automobile industry, mould-making, plastics industry, bookbinding. The HAP aluminium heating plates cover a temperature range up to 250°C ...

heating strip / flexible / for plastics welding / silicone
heating strip
UPS

Maximum temperature: 200 °C
Power: 1 W - 50,000 W

... dishwashers, cooking plans, kettles, heating bands for drums and many others. The technology, unique in its kind, consents to minimize the thickness of the heating element while allowing a very intense ...

tubular heating element / flat / flexible / ring
tubular heating element
UPS

Maximum temperature: 200 °C
Power: 1 W - 5,000 W

... dishwashers, industrial applications, kettles, heating bands for drums and many others. The technology, unique in its kind, consents to minimize the thickness of the heating element while allowing ...

heating strip / flexible / for plastics welding / polyimide
heating strip
UPS

Maximum temperature: 0 °C - 250 °C
Power: 1 W - 1,000 W

... military and many others. This unique technology consents to minimize the thickness of the heating flexible element while assuring a very intense heating production with temperatures up to 200°C continuously ...

heating strip / ceramic / silicon nitride
heating strip

Maximum temperature: 1,000, 500 °C

Description Flat heating elements made of silicon nitride are normally rectangular. Various measurements and batch sizes up to our mold diameter of 400 mm can be produced. The special properties and the low mass of ceramic ...

heating strip / ring / ceramic / silicon nitride
heating strip

Maximum temperature: 500 °C

... Ceramic heating rings made of silicon nitride can be produced with an outer diameter of up to 300 mm. A typical extent of the rings is 5 mm. The good thermal conduction and the low thermal mass of the ceramic material ...

heating strip / ceramic
heating strip
HTCC/MCH

... applications, such as kerosene or gas appliances, igniter, heater or vaporizer, water-heating applications, heater for soldering iron, seal heater, and liquid heater ...

heating strip / ceramic
heating strip

Ceramic heating blade for IOQS. Custom designs are available for us.

tubular heating element / flat / flexible / polyester
tubular heating element

Maximum temperature: 20 °C - 200 °C
Power: 2.3 W - 2,000 W

... into place •electronic regulation in heating systems Areas of Application: •surface heating elements •electric heating cushions and heating blankets •heating ...

heating strip / ceramic
heating strip
8033-xx series

Maximum temperature: 300 °C
Power: 250 W - 2,000 W

... inside a stainless steel casing. Loads: 4 to 6 W/cm2. They can equally be used to heat large surfaces by grouping several heaters side by side. Supply voltage :230V 1P.

See the other products
Vulcanic
heating strip / mica / armored
heating strip
4027 series

Maximum temperature: 300 °C
Power: 200, 300, 400, 700, 800 W

... flat surfaces up to 300°C (hotplates, tanks, moulds, tools). Load 4 W/cm2. Must be firmly clamped to the heated surface (along the entire heated length, Lc). With protective steatite caps. Supply voltage :230V 1P.

See the other products
Vulcanic
heating strip / ceramic
heating strip
4033 series

Maximum temperature: 600 °C
Power: 250 W - 2,000 W

To heat flat surfaces up to 600°C (300°C for models with threaded terminals). These ceramic-insulated elements have In a stainless steel sheath Supply voltage :230V 1P

See the other products
Vulcanic
heating strip / ceramic fiber
heating strip

Maximum temperature: 450 °C

Three high temperature resistant specialist magnets independently hold the magnet preheater in its place. The back insulation is made of 25mm ceramic fibre in Inconel wire mesh, the back protector is a robust box construction made of ...

See the other products
Weldotherm GmbH
heating strip / mica
heating strip

Maximum temperature: 340, 180 °C

without sheath UL recognized mica strip heaters, without sheath

See the other products
acim jouanin
tubular heating element / flat / ceramic fiber / molybdenum
tubular heating element
Superthal

Maximum temperature: 1,750 °C
Power: 1,050 kW - 2,950 kW

Prefabricated heating modules consisting of vacuum-formed ceramic fibre with an integral Kanthal Super molybdenum disilicide (MoSi2) heating element for up to 1750°C (3180°F) element temperature. Superthal ...

heating strip / compact
heating strip
RO 350

Maximum temperature: 80 °C
Power: 350 W

... types of contact heaters are designed and made for preheating and maintaining oil at a constant temperature in air-cooled endothermic engines. They are in fact applied in contact under the oil sump. An adjustable thermostat ...

See the other products
SYSTEM di ROSATI
tubular heating element / flat / ceramic fiber
tubular heating element
FIH

Maximum temperature: 0 °C - 1,100 °C
Power: 0 W - 1,200 W

... manufacture of custom heaters for OEM furnace and thermal process equipment manufacturers as well as for end users with unique and demanding radiant heater requirements. The lightweight ceramic fiber ...

See the other products
ZIRCAR Ceramics
tubular heating element / flat
tubular heating element

flat tubular heaters are particularly suitable for applications where increased contact heating is required two cross sections: 12,5 x 6 mm and 16 x 6 mm length: up to 2500 mm loads: up to 25 W/cm² connection ...

See the other products
Vimosa d.o.o.
heating strip / mica
heating strip
GM.55

Maximum temperature: 350 °C
Power: 5,000 W

For heating molds in plastic moulding industry. Molds for plasic. Molds in plastic extrusion. Flat surfaces for presses. Packaging machines. Thermofotmig machines. Food industry machines. Advantages of the Mica Band ...

mica heating element / flat / custom
mica heating element

Maximum temperature: 500 °C

... etched foil mica heaters provide uniform heat with fast response. Operating temperature range -150°C (-238°F) to 500°C (932°F). A distributed wattage etch foil heater element is bonded between high-temperature ...

heating strip / zinc-plated steel / brass / stainless steel
heating strip

Heaters providing heat by conduction to flat surfaces are an example of versatility of the models with mica insulation for heat applications. These heaters provide heat by conduction to flat surfaces. ...

heating strip
heating strip

heating strip
heating strip
FLC

Maximum temperature: 750 °C

Description Flat heating element with CrNi-steel sheath and integrated tubular heater type RHK. application Heating of surfaces, e.g. heating boilers, heating ...

heating strip / ceramic
heating strip
PCB

Maximum temperature: 600 °C

... used up to 600°C (1112°F) with a maximum Watt density of 7W/cm² (45W/in²). They have a longer lifespan than Sheathed Mica Strip Heaters (PMB) but are less resistant to compressions.

heating strip / mica / armored
heating strip
Micanit

... Centred mounting hole diameter 10 -15mm Further design features as for strip heating element Functional characteristics Defined heating capacity through resistance wire technology ...

heating strip / ceramic
heating strip

Maximum temperature: 90 °C - 240 °C
Power: 15 W - 250 W

These small ceramic stones are PTC heating elements with self-temperature limiting characteristics. Their heating response times are fast, and they plateau when the pre-defined reference temperature is ...

heating strip / mica / armored
heating strip
TYP.MH302

Maximum temperature: 350 °C

... Application These heaters are designed to use in processing all kinds of plastic raw materials, output molds of extruders machines and textile machines. It can be produces square, rectangle and optionally width, length ...