Voltage: 230, 24, 100, 70 V
Current: 1.38 A
Power: 250 W
... Rated current 1.38 A • Output power 250 W • Power consumption with mains operation at rest 9.9 W • at rated power 318 W • Operating voltage (emergency power ...
detectomat GmbH
... package are optional Application • An amplifier can boost the (average) power of a laser output to higher levels (→ master oscillator power amplifier = MOPA). •It ...
Voltage: 38 V - 265 V
The WS-56EYAxx series high-power optical amplifier is a high-power multi-port output fiber amplifier with a gain spectrum bandwidth of 1535~1565nm. It is mainly designed ...
WSEE
Voltage: 12 V - 14 V
Power: 1 W
Frequency: 5.2 GHz - 5.8 GHz
... switch. If the TRX input is without power, the device is in the receive mode. In order to switch to transmission safely, the input should have a power of at least -10 dBm. It should also be noted that ...
Voltage: 0.78 V - 1 V
Power: 1,800 W - 5,500 W
Frequency: 20 Hz - 20,000 Hz
Voltage: 100 V - 230 V
Power: 0 W - 3 W
Frequency: 1 kHz - 50 kHz
... applications the new MOPA microlasers from STANDA utilize Master Oscillator Power Amplifier platform that combines company's renowned STA-01 microlaser oscillators together with a highly ...
Frequency: 71 GHz - 86 GHz
... non-terrestrial E-Band communications. 71-76GHz and 81-86Gz High Power Amplifiers A range of configurable options integrating high power amplifiers (PAs) ...
Voltage: 150 mV
Current: 4,000 A
Frequency: 5,000 Hz
PWA series power amplifier is composed of power exchange unit, electric control unit, signal modulation and protection unit, driving unit, power amplification ...
Voltage: 5 mV
Current: 59 mA
... innovative power saving facility which when enable can offer up to 450 hours battery life with a 350 ohm bridge connected. In normal power mode up to 35 hours battery life is achieved with a 350 ohm bridge. ...
Althen sensors
Voltage: 3.3 V
Current: 5.6 mA
Frequency: 22 Hz - 29 Hz
... the k-band. The Low Noise Amplifier chip comprises a gain control function to choose between low- and high-gain mode, both providing a linear amplification. A power enable pin allows for switching between ...
Power: 5 W
Frequency: 750 MHz - 4,000 MHz
... need external DC power supply ● Wide Freq range 750-4000MHz ● Small Size:2.0 x 2.0 mm ● Very Low Loss & Low VSWR ● Excellent directivity ● Broad frequency coverage ● High isolation ● Good Repeatability ● Tape ...
Yantel Corporation
Power: 500, 300 W
Frequency: 15 Hz - 20,000 Hz
power amplifier Main Features ●It has high efficiency and energy saving that is unmatched by traditional analog power amplifiers. ●Long life, under the combined ...
Power: 400 W
... overtemperature, over-current and high reflected power. The amplifier is equipped with precise forward and reflected power detection circuitry for correct configuration and monitoring ...
ELBER
Power: 3, 9 kW
The 5CX1500A is designed for use as a Class C rf power amplifier in radio frequency applications. For FM broadcast service, the 5CX1500B is recommended in place of the 5CX1500A, for improved reliability.
Voltage: 8 V
The A275 is a high performance hybrid differential op-amp developed as a pulse amplifier for spaceborne nuclear instrumentation. Its low power dissipation (15 mW), high slew rate (100 V/µs), and low ...
Digital power amplifier for single solenoid and double solenoid valves Usable as a replacement of PAM-195, PAM-196 and PAM-197 For all typical proportional valves of all manufacturers ...
W.E.S.T.
Voltage: 0 kV - 50 kV
Current: 0 mA - 12 mA
... Specifications Output Voltage Range: 0 to ±50 kV DC or peak AC Output Current Range: 0 to ±12 mA DC or peak AC Slew Rate: Greater than 350 V/μs Large Signal Bandwidth: DC to greater ...
TREK, INC.
Power: 180 W
... LCD Display Description The Power Amplifier Type PA14-180 has been developed to drive any type of exciter requiring a 180 VA power amplifier. It has a useable frequency ...
Voltage: 24 V
Current: 5 mA
Montalvo s M-3224 Strain Gauge Load Cell Amplifier is powered by 24 VDC. The M-3224 is used in conjunction with one or two load cells to indicate and monitor web tension by amplifying the load cell signal.
... The evaluation unit supplies a high frequency signal from which the energy for the sensor signal amplifier is generated. This in turn generates the power supply for the connected sensor. The bridge supply ...
Voltage: 1.8 V - 5.5 V
This IC is an audio power amp that can operate at low voltage. Operating supply voltage supports 3V and 5V power amp, making it ideal for applications such as mobile phones and other portable communication devices. ...
Voltage: 30 V - 420 V
Current: 2 mA - 20 mA
HV-LN Series Low Noise Power Amplifier The Model LN power amplifiers offer extended output power, voltage capabilities, low distortion, versatility ...
Advance Instrument Inc.
The F6300 High-Power Current Amplifier works in combination with the F6150 Power System Simulator to bring your realistic protection scheme testing power to the next ...
Audio Messages diffusion is managed by a digital audio amplifier (IP AMPLIFIER) specifically engineered for railways application. It is a network amplifier for PA coach systems with 3 ...
Voltage: 10 V - 30 V
Current: 2 A
Power: 1 W
... Isolating switching amplifier Ex version - yes Approvals - ATEX Functional safety (SIL/PL) - SIL2 Nominal voltage - Power bridge 24 VDC Number of channels - 2 Digital output - Relay output Connection ...
TURCK
Voltage: 24 V
Current: 0.1 A
Power: 1 W
... Isolating switching amplifier Ex version - yes Approvals - ATEX Functional safety (SIL/PL) - SIL2 Nominal voltage - Power bridge 24 VDC Number of channels - 2 Digital output - Transistor output Connection ...
TURCK
Voltage: 24 V
Power: 3 W
... Temperature measuring amplifier Ex version - yes Approvals - ATEX, IECEx, INMETRO, TR CU, NEPSI Functional safety (SIL/PL) - SIL2 Nominal voltage - Power bridge 24 VDC Number of channels - 2 Connection ...
TURCK
Please specify:
Help us improve:
remaining