Thermal plates CtP processor cleaners

Plate width: 200 mm - 850 mm
Plate length: 275 mm

... to go: the unit is designed to handle up to 60,000 m² of plates a year! Small ecological footprint These units are energy-efficient, chemistry-free and no water is required to clean the plate. Reduced ...

Plate width: 200 mm - 900 mm
Plate length: 310 mm - 1,400 mm
Throughput: 26, 37 p/h

... well-known Azura C95 and C125 are specifically designed for Azura TS plates of up to 95 and 125 cm wide. You either install them on a stand-alone basis or connect them online with the plate setter (through ...

Plate width: 200 mm - 850 mm
Plate length: 275 mm - 1,400 mm
Throughput: 95, 67 p/h

... online with the platesetter or stand-alone. There’s no need for a developer or replenisher and everything is pre-set. So once the Azura CX clean-out unit is installed, you’re good to go: the unit is designed to handle ...

Plate width: 200 mm - 1,250 mm
Plate length: 300 mm
Throughput: 44 p/h

No matter which size thermal plates you use, the Elantrix DX is the all-round thermal plate processor for you, even for heavy-duty applications. Deliver ...

Tank capacity: 46 l - 64 l
Plate width: 860 mm - 1,200 mm
Plate length: 325 mm

... and container levels. The choice of Tiger processor will depend on the type of CRON CTP engine to be supported. They available in two widths: 86cm and 125 cm (33.9” and 49.2”) and can be used for both ...

Plate width: 0 mm - 1,400 mm

Machine for washing aluminum offset plates after printing, very fast and accurate. Designed for removing ink used after printing, washing and applying protective rubber for archiving. ECOMATIC ...

Tank capacity: 0 l - 20 l
Plate width: 1,200, 850 mm
Plate length: 300 mm

... free plates, updated version 2017. You don't need repinishment and develop, no need of PH, Temperature. Speed and brush control through a new smart control panel. Very compact and robust with internal PVC tank, it ...

... DESCRIPTION The Cosmoline inline washer and drying unit processes photopolymer plates. The operator feeds a plate into the machine on one side and exits on the other side. After placing ...