Mineral-insulated heating cable ELK-MI AY 825

for pipe trace heatingfor tank tracingfor freeze protection

MI-trace heaters consist of a single or two conductor series trace heater connected to mineral-insulated cold leads by means of a clean laser seal (splice). The outer sheath material is Alloy 825. The free end of the cold lead is potted and fitted with a flexible lead (cross section matching that of the cold lead conductor) for power connection and a 1.5 mm² (0,002325 in²) lead for earthing. A compression ring flameproof stainless steel gland 1.4404 (AISI 316L) threaded M20x1.5 or M25x1.5 is fitted at the end of each cold lead and prevented from possible loss by the potted end seal. MI trace heaters are supplied prefabricated by eltherm and ready for installation. Each unit comes with a type plate bearing all information / markings. Maximum maintain temperatures are derived from the maximum sheath temperature determined by eltherm and are also indicated on the type plate. Technical Benefits -Purity: No foreign material -Full range of resistances -Fast assembly, low cost -1 mile (1,6 km) on 1 circuit -In by noon, out by 5 -100% quality check -Safety: non-destructive tests -No filler holes. -MgO = ASTM E1652 Technical Data Output, max. Up to 250 W/m Nominal voltage Up to 300 / 600 V Protection class I Bending radius, minimal Diameter x 6