Constant-wattage heating cable ELP/Si series

silicone-insulatedfor pipe trace heatingfor freeze protection

The installation of this heating cable is highly cost-efficient with any kind of heat tracing application thanks to the single end power input. The heating cable consists of a succession of heating zones (length = contactspacing) and can be cut to length in sections of the contact distance to the required length. When cutting into lengths, the heating circuit is interrupted up to the next contact point and this non-active part can be used as a cold lead. During the design phase, one contact spacing length per planned heating circuit must be calculated additionally. Technical Benefits Single end connection Can be cut off the roll Constant power output per meter Highly flexible Moisture proof Technical Data Protective braid Copper Outer jacket Silicone Bending radius, min. 30 mm Bus wire cross section 2 x 1,5 mm² Nominal voltage 230 V Installation temperature, min. - 60 °C Start-up temperature, min. - 60 °C Insulation Silicone