Three-phase harmonic filter reactor MRA series

MRA reactors are filters for harmonics, used to prevent resonances occurring, which are extremely dangerous situations for the electric system because of the ensuing overcurrents and overvoltages. The “block” reactors are used with the sole purpose of correcting the power factor of the loads generating harmonics; the filter is therefore tuned only to a single frequency below the lowest one present. The most commonly used tuning frequencies are: 210 Hz corresponding XL = 5,7% XC 189Hz corresponding XL = 7% XC 134 Hz corresponding XL = 14% XC Normally, reactors to block harmonics are singlephase with an air core, but three-phase reactors can be used with an iron core for limited powers; the main difference is that reactors with an air core do not saturate but they are bulky, while reactors with an iron core saturate but they are smaller. In both cases the reactors are set in series with the bank of three-phase capacitors and types can be made for either indoor or outdoor installation. The “filter” reactors are used with the aim of reducing the factor of distortion; the filter is therefore tuned to a frequency close to that of the harmonics present. If there are several harmonics to filter, then different filters will need to be made associated with separate banks of capacitors. The reactors are typically single-phase with an air core. The filter reactors are set in series with the bank of three-phase capacitors and can be made for either indoor or outdoor installation.