The laboratory electric burner is constructed as follows:
Stack made of heat-, acid- and alkali-resistant ceramic material with continuous opening, diameter 38 mm.
Enclosed heating system design, thus insensitive to overflowing fluid.
After a short heating time, the inside of the stack is red hot and a strong stream of hot air emerges at the top.
There is no limitation on the working time as long as needed. The unit can be easily switched on and off by the shock- proofed plug with included toggle switch or using the power regulator.
A square tube on the inside of the stack, made of heat- resistant and acid- resistant alloy, serves as a heat exchanger and is electrically isolated.
Just connect it to the electrical plug in the laboratory.
Flasks and dishes can be put straight on the 6 small elevation on the top of the stack. Additionally we have a glass support, shown below.
overall- size 17cm or 6.6″ in height
base diameter is 12.5 cm or 5″
power rating is 811 W/230 V/50 Hz
Optional accessories: perfect work in the laboratory
The following accessories are currently available for the laboratory electric burner:
Stainless steel stand with contact protection – for safe placement of flasks and dishes in the heat stream.
Safety stand – increased contact protection made of stainless steel
HORO-power regulator – control unit for the Electrical Laboratory Burner: nominal power of the power regulator 1000 W: controls the burner power between 0 and 100%. No power-on spikes thanks to soft start for optimum power consumption and output. Please note: other power controllers commercially available are not suitable!