Stabilizer-dimmer ITR500-001

6 CH 10A Ballast Controller Each channel can dimming on ballast with 0-10V,1-10V and 2-10V method. Relay for current carrying value of 10A per channel is also available, it can be controlled manually. Active and / or passive ballast types can be connected. It has 6 channel. DESCRIPTION ITR500-001 can dimming from 0V to 10V for per channel. The outputs for MAX 10A be switched ON or OFF on every output channel, also can manually switch. Control types include both input and output, so, Absorption and output type ballast can be connected to this module. LAYOUT AND WIRINGS • Special Programming: This device is designed for professional KNX installation. It can only be programmed by ETS software. • Check Connections: Re-tighten all connections after installation. • Output Circuit: The load on the switched circuits must not exceed the specified capacity of 10A, these circuits should be fed via a 10A fuse/circuit breaker IMPORTANT NOTES • Labeling for AC power wires, loads wires and KNX/EIB wire. • Mount the device on a DIN rail of distribution box. • Connect wires for loads. • Make sure there is no short circuit or open circuit. • Make sure the KNX cable type is correct and has no short circuit. • Connect KNX cables. Make sure the color is correct. • Tidy the all Wire and separate KNX wire from AC power wire. • 6 Channel 0-10V dimming and maximum 10A relay output for every channel. also can manually switch. • The switch functions: Statistical total ON time, Status response, Status recovery, Upper limit, Lower limit, Staircase light, Scene control, Scene dimming, Sequence control, Threshold switch, Heating actuator( PWM). INSTALLATION STEPS