Finishing paint Safety Grip®

anti-sliptwo-componentepoxy resin

For steps, ramps and floors, in wet or oily areas. Coarse anti slip finish to reduce accidents Slip resistant even when wet or oily Our best selling coating for over 40 years Watco Safety Grip is a heavy duty, coarse textured, anti slip, two pack epoxy resin coatings designed to provide a safe surface both inside and out. Using one high build coat of Safety Grip minimises the risk of accidents throughout the workplace, particularly for wet or oily areas. All grades now carry CE Mark EN 1504-2 and have test results for slip resistance, abrasion, scratch and impact resistance, as well as for adhesion and hardness. They are also chemical resistant and have an A+ VOC emissions rating with a low level of VOC. Recommended areas of use Slippery, hazardous, wet or oily areas Around machinery Steps, ramps/ disabled ramps, foot bridges Loading bays, walkways and entrance ways Car parks Around vibrating machinery (see Safety Grip Flex) Application Surface preparation Bare Concrete – remove surface laitance, dust and any light dirt or grease deposits using Watco Etch & Clean. Watco Etch & Clean also etches smooth, bare concrete surfaces to provide a key. Flush with clean water and allow the surface to dry. For the removal of heavier deposits of oil and grease we recommend Watco Concroff, again, flush with clean water and allow the surface to dry. New Concrete – as a guide, new concrete should be left for 8 weeks to dry. The surface should then be prepared using Watco Etch & Clean, thoroughly rinsed and left to dry.