{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
... digital inputs and outputs, as well as an analogue output. The communication with higher-level systems . The parameters required for electrical systems can be set either via Modbus RTU or via the NFC interface and ...
BENDER GmbH & Co KG
... measuring current transformers. The maximum voltage of the system to be monitored depends on the nominal insulation voltage of the measuring current transformer used in the case of busbar systems, resp. depend on the ...
BENDER GmbH & Co KG
... measuring current transformers. The maximum voltage of the system to be monitored depends on the nominal insulation voltage of the measuring current transformer used in the case of busbar systems, resp. depend on the ...
BENDER GmbH & Co KG
... measuring current transformers. The maximum voltage of the system to be monitored depends on the nominal insulation voltage of the measuring current transformer used in the case of busbar systems, resp. depend on the ...
BENDER GmbH & Co KG
... measuring current transformers. The maximum voltage of the system to be monitored depends on the nominal insulation voltage of the measuring current transformer used in the case of busbar systems, resp. depend on the ...
BENDER GmbH & Co KG
... used as additional protection (protection against indirect contact) in earthed systems (TN and TT systems) in which AC or DC fault currents may occur. Part of these systems are particularly loads containing ...
BENDER GmbH & Co KG
... The residual current monitoring modules of the RCMB300 series are intended for measuring AC and DC fault currents in earthed systems (TN and TT systems). The modules are able to measure ...
BENDER GmbH & Co KG
... thus intended in particular for monitoring final circuits. Two separately adjustable response values allow a distinction to be made between prewarning and alarm. The devices feature an RS-485 interface with either BMS ...
BENDER GmbH & Co KG
... RNGR with passive and active measurement methods Continuous monitoring of the RNGR even if the installation is de-energised; Alarm or trip on ground fault Monitoring of the current INGR Monitoring ...
BENDER GmbH & Co KG
... easily connect to a supervisory system with Modbus TCP/IP or RTU communications. Capabilities extend to 25 kV and 2,000 A. Features Determination of RNGR with passive and active measurement methods Continuous monitoring ...
BENDER GmbH & Co KG