Moldino clamping milling cutters

Diameter : 2.5 mm - 10 mm
Length: 50, 100, 60, 75 mm

It achieves a significant reduction in machining time for high-hardness molds and serves as a bridge to 5-axis machining with zero steps. High-efficiency, high-quality processing of sloped surfaces ...

Diameter : 0.1 mm - 12 mm
Length: 35 mm - 100 mm

... type with the shortest neck length has been added to the lineup. New coating TH3 for machining hardened steel Optimized flute shape for high-hardness steel machining Double face shape Features and ...

Diameter : 0.9 mm - 20 mm
Length: 50 mm - 200 mm
Rotational speed: 2,300 rpm - 50,000 rpm

... high-efficient side milling cutting (high hélix peripheral cutting edge) Smooth connection at joint between bail edge and high hélix peripheral cutting edge.Enables ...

Diameter : 0.3 mm - 20 mm
Length: 50 mm - 160 mm

... Realizes longer tool life in cutting prehardened Steel such as HPM-MAGIC, carbon Steel, alloy Steel, stainless Steel, hot and cold tool Steel, etc. By improving heat résistance, longer tool life is achievable for ...

Diameter : 0.1 mm - 12 mm
Length: 50 mm - 200 mm

Pencil Deep Ball Evolution Evolution version of Pencil Deep Ball New variations of neck angle and under neck length have been added. Neck angle that was previously in the EPDBP-TH lineup has been expanded. You can select the tool ...

Diameter : 0.2 mm - 2 mm
Length: 50, 55 mm

Cutting resistance is low, so the finishing surface is excellent and finish accuracy is higher. Fine (F) type: Prioritizes high-accuracy machining Strong (S) type: Prioritizes stable machining Two ...

Diameter : 3 mm - 25 mm
Length: 60 mm - 150 mm

... lineup suitable for machining size . End cutting edge with focus on cutting performance enables high-feed-rate cutting in Z direction. The end cutting ...

Diameter : 6, 12, 10, 8 mm
Length: 60, 80, 70 mm

... Cautions on use ・Dry (air blow) cutting is recommended. ・Use of hydro chucks (hydraulic holders) or shrink-fit holders is recommended. ・Down cutting is recommended. ・Continuous cutting ...

Diameter : 20 mm - 40 mm
Length: 30 mm - 40 mm

Realizes a significant reduction in machining time for mold machining. Achieves highly efficient finishing of inclined wall surfaces Develop large diameter series Economical 2 corner specification

Diameter : 12 mm - 30 mm
Length: 26 mm - 43 mm

... edge, and machining the corner and its adjacent surface without changing the tool can reduce the machining step. Two types of cutting edges can be used with one tool by taper-shaped ...