The angled belt conveyor GAL-25-K-W has a frame with only 25 mm height. It can therefore be used even in very confined spaces.
The very rigid TorsioDur frame gives a high resistance against torsion which results in high reliability in spite of very small dimensions.
Equipped with a corrugated edge belt it can handle even the smallest parts without any danger of jamming or damaging them.
The angle of inclination can be infinitely adjusted between 40 and 60° from the ground.
The frame has grooves for sliding blocks with M-6 threads on both sides, where additional accessories can be fixed . An overview of accessories available in our standard programme can be found on page 45 and onwards.
The length of the horizontal and the rising section of the conveyor can be adapted to the specific needs of each application. The total length however should not exceed 3 metres.
Hoppers and side rails can be added to the GAL-25-K-W when needed. They will ensure a safe transport of the goods.
In standard configuration the horizontal section has small casters, so the conveyor can easily be moved. A double support is fixed to the rising section, as shown in the picture above. An H-shaped support on wheels with security brakes, as shown on page 11, can also be used.
The universal transport solution, for applications where no cooling lubrication is present.
* Also suitable for parts with sharp edges
* Not suitable for transporting hot chips
Our belt conveyors are predominantly used on punch-nibbling machines, for transporting punching scrap and punching trimmings. However, other parts can also be transported, such as waste parts from plastic injection machines. The transport belt of the conveyor is resistant to oil and grease.
Structure:
*Housing made of steel plate
*Oil-resistant belt
*Protective motor switch
*Convex return shafts
*Shafts with ball bearings
*Adjustable belt tension
Flexible lacing with self tapping screws for heavy duty belts up to 30 mm thick:
- No drilling preparation, no template
- The screws drill themselves through the belt
- Good compatibility with scrapers
- Very long life time.
- Installation regardless of weather conditions
- Possible to use for an emergency splice of a steel cord belt
Material:
Reinforced rubber corresponding to conveyor quality: wear resistant, heat resistant, oil resistant, fire resistant, white FDA, textile on the bottom and non magnetic.
Installation:
By using an electric screw driver, a hand brace or a pneumatic screw driver.
Packaging:
In length up to 3 m in one piece or on roll up to 25 m long.
