|
|
| ... products without technical information |
| |
|
|
|
|
Flexco® Bolt Solid Plate fasteners are engineered to meet the demands of the toughest material-handling applications. They can be applied to belts mechanically rated up to 620PIW (105 kN/m), and are commonly used on higher-tension main-haulage belts used for highly abrasive materials such as sand, gravel, and crushed stone, as well as coal, cement, and salt.
Bolt Solid Plate fasteners provide a strong, sift-free splice with superior holding ability. The strength of this fastener is derived from the compression of the plates with high tensil strength bolts. The bolts compress top and bottom plates to distribute splice tension evenly across the entire width of each fastener plate. For added strength and pull-out resistance, specially formed teeth penetrate deep into the belt carcass - without damaging the carcass fibers.
Specially designed templets, punches and boring tools make it easy to quickly and accurately punch holes into belts. Fasteners can then be installed on site using portable hand or power tools. The exclusive Flexco piloted bolt speeds installation. The piloted bolt tip cradles nuts securely in place, and simplifies installation by automatically aligning the bolt and nut threads.
|
|
Traditional fastener for rip repair and lacing.
Typ 140, 190, 1 ½, 2, 2 ½ & 3 for belts up to 25 mm thick.
Installation with a template, a driller and a wrench.
Material:
Fastener made of carbon steel galvanized or wear resistant special steel or stainless steel with a nylon washer holding the bolts.
Installation:
A template helps to make the holes with a driller. Using a wrench for screwing the nuts and a bolt breaker.
Packaging:
Standard box with 25 pre-assembled fasteners Type 140, 190, 1 ½, et 2.
Standard box with 10 pre-assembled fasteners Type 2 ½ et 3.
Bucket wit 100 pre-assembled fasteners.
|
|
|
|
