Voltage: 24 V - 230 V
... ATEX amplifier series 400 for Ex flow sensors ST.../STS... Designs for AC or DC supply voltage Rail mounting in the control cabinet Visualisation of the flow rate via LED strip To activate and deactivate fans and ...
Voltage: 0.5 mV - 10 mV
Current: 4 mA - 20 mA
Frequency: 1,000 Hz
... FUTEK's IAA200 Analog Amplifier with Current Output is FUTEK’s brand new general purpose amplifier solution for in-line amplification of any full bridge strain gauge type sensor with mV/V range output. ...
FUTEK Advanced Sensor Technology, Inc.
... • Video signal amplifier transmitter and receiver • Video analog/digital signal converter for twisted-pair wiring • Design suitable for mobile use • Video signal is adjusted according to transmission length ...
Voltage: 0 V - 1,000 V
Current: 7 A
Power: 7,000 W
... generates an output voltage up to 1000 V and an output current of 7 A. The switching amplifier RCV 1000/7 operates as an amplifier with energy recovery. This amplifier principle is especially suited ...
piezosystem jena GmbH
Voltage: 24 V
... Load cell signal amplifier for weighing systems that do not require direct weight display General Description Analog load cell signal amplifier that can be connected directly to a PLC for weighing ...
Voltage: 12 V - 28 V
Current: 25 mA
Frequency: 1 Hz - 5,000 Hz
... Our ECO pulse amplifiers can be equipped with all KEM flow meters. The amplifier system includes a single tap with temperature range up to +150 °C and double tap for higher resolutions or bi-directional flow measurement ...
... settings Gain settings of 2, 10 and 20; gain error ±0.01% Multiple PD-AO-AMP-115s connect directly to PCI or PXI analog output high-voltage cards PSU-AO32G115 supplies power to drive two AMP-115s (32 ...
Voltage: 100 V - 1,200 V
Frequency: 2 Hz - 20,000 Hz
... • Designed with state-of-the-art MOSFET transistors • Sine output power up to 1200 VA • Selectable operation in current or voltage mode • Backgroundlit multifunctional display • Safety management system monitors temperature, overcurrent, clipping ...
... features This type of instrument is to be used to amplify the analogic signal in mV detected by load cells (max 4 with 350 Ohm impedance). The supply is 24 Vcc +/- 10%, which is transformed by a power supply in commutation and generates the voltages ...
Celmi
Voltage: 26 mV
Current: 200, 150 mA
Power: 5 W
... Universal measuring amplifier for load cells with integrated analog/digital converter About the LCB Digitizer/Weight Trasmitter for load cells conceived with an eye on IoT (Internet of Things) (Internet of Things). ...
Althen sensors
the best suppliers