{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Frequency: 703 MHz - 2,570 MHz
... equipment. The CCI bandpass filters eliminate this effect by blocking unwanted signals outside of the frequency range of interest and enabling a clear visualization of the signals present in the uplink range. The bandpass ...
Frequency: 18 Hz - 220 Hz
... requirements. Standard Waveguides Sizes WR-42 to WR-05 Low Pass Band Insertion Loss Narrow Pass Band High Power Capabilities Space Qualified
Frequency: 24 MHz - 3,000 MHz
... the factory for your specific requirements. An additional feature of our Tunable Filter Product Line is the ability to ship standard bandpass and bandreject filters overnight from stock.
Smiths Interconnect's Switched Filter Banks typically include multiple filter topologies, including PIN diode and MMIC switch sub-circuits to achieve operational bandwidths of greater than 3 octaves. ...
Current: 30 A - 400 A
Voltage: 480, 400 V
Frequency: 60, 50 Hz
... filtered for maximum filter effectiveness Power factor correction both inductive and capacitive Phase current balancing, improvement of consumption in neutral (4W model) If higher filtering capabilities ...
Voltage: 400, 480 V
Frequency: 50, 60 Hz
LCL filters have been specially designed to eliminate the harmonics from the current absorbed by 6-pulse power converters, such as frequency variators for motors, UPS, etc. These are essentially passive filters ...
Current: 6 A - 20 A
Voltage: 250 V
Frequency: 400 Hz - 3,000,000,000 Hz
The FN 700Z 3 stage EMC/EMI filter that has an IEC inlet for 6 and 10A versions by Schaffner® is a high surge voltage protection with a very high attenuation performance that is up to 3GHz attenuation. It has a frequency ...
SCHAFFNER Group
Current: 35 A - 300 A
Voltage: 520, 300 V
Frequency: 60 Hz
FN 3100 series 3-phase filter assembly is an electromagnetic compatibility and interference system for regenerative motor drive. It features an enhanced broadband attenuation output from 10 up to 30 MHz. This filtering ...
SCHAFFNER Group
Current: 7 A - 180 A
Voltage: 300, 277 V
Frequency: 60 Hz
The FN 3258 Ultra-compact EMC/EMI filter for 3-phase systems and motor drives by Schaffner ® is an extremely compact and slim filter design that allows a trouble-free installation even where the available ...
SCHAFFNER Group
Current: 1,000 A
Frequency: 45 Hz
... interference filters Drives with rectifier supply produce low and high frequency system interference with their pulse-type charging currents, which are limited by EMC regulations. Compliance with standards is ensured ...
KEB Automation KG
Frequency: 45 Hz - 65 Hz
Harmonic filters are KEB's innovative solution to reducing network harmonics. The units can be planned simply as a power choke right from the design stage of an electrical switchboard, for compliance with many of the ...
KEB Automation KG
Frequency: 100 Hz - 400 Hz
... COMBILINE sine wave filters limit loads to the admissible limit values and provide the necessary protection of enamel insulation and winding heads on long motor lines and special motors. Protection by sinusoidal ...
KEB Automation KG
Frequency: 824 MHz - 5,900 MHz
Pasternack RF bandpass filters (BPF) are tractable coaxial elements that permit particular frequencies to move within a specific distance and declining frequencies (attenuation) beyond that range. Bandpass RF filters ...
Pasternack Enterprises, Inc.
Frequency: 100 MHz - 3,000 MHz
... tunable band pass filters and band reject filters (also referred to as band-stop filters or band-rejection ...
Pasternack Enterprises, Inc.
Pasternack WR-28 waveguide bandpass filters are low loss RF components capable of handling high power with high isolation. Our WR-28 waveguide bandpass filters components from Pasternack are commonly ...
Pasternack Enterprises, Inc.
Frequency: 5 kHz - 20,000 kHz
Main Features Data protection, control line protection Up to 100dB Bandwidth from 5kHz to 20MHz Typical Applications HEMP Anechoic chambers Faraday Cages Shelters
EXXELIA
Frequency: 5 kHz - 20,000 kHz
Main Features Data protection, control line protection up to 100dB Bandwidth from 5kHz to 20MHz Typical Applications TEMPEST TEMPEST zoning Anechoic chambers Faraday Cages, Shelters
EXXELIA
Current: 64 A
Voltage: 28 V - 240 V
Main Features Low profile housing up to 70dB Typical Applications Engine Protection AC or DC power supply protection
EXXELIA
Current: 20 A
Voltage: 380 V
Frequency: 50 Hz
SKS-OCL series Load Reactors are placed in series with electrical equipment to introduce a specific controlled impedance to the AC circuit. This series are applied at AC drive output side to suppress inrush voltage, reducing inrush and ...
Frequency: 2,400 MHz - 2,500 MHz
Features Compact and Low-profile Low loss and high attenuation Stable temperature characteristics
Taiyo Yuden
Frequency: 2,400 MHz - 2,500 MHz
Features Compact and Low-profile Low loss and high attenuation Stable temperature characteristics
Taiyo Yuden
Frequency: 2,400 Hz - 2,500 Hz
Features Compact and Low-profile Low loss and high attenuation Stable temperature characteristics
Taiyo Yuden
Frequency: 1 Hz - 15,000 Hz
... may vary in frequency due to load factors,. Variants BP/04/N provides narrow band frequency filtering between 1 Hz - 15 kHz. BP/04/W provides wide band frequency filtering ...
Current: 30 A - 200 A
Voltage: 380, 600 V
Frequency: 50 Hz
With the development of power electronic technology, the application of power electronic equipment, such as all kinds of rectifier, is widely used in industry, traffic and domestic appliance, and the ...
Current: 1, 2 mA
Voltage: 115, 250 V
Frequency: 50, 60 Hz
• Rated voltage : 115/250 VAC • Power line frequency : 50/60 Hz • Climatic category : HMF 25/100/21 • Max. leakage current for standard version each line to ground @ 115VAC 60Hz: 1,0mA @ 250VAC 50Hz: 2,0mA • Hi-pot rating ...
Current: 1, 4 mA
Voltage: 440 V
Frequency: 50, 60 Hz
• Rated voltage : 440 VAC • Power line frequency : 50/60 Hz • Max. leakage current for standard version each line to ground @ 10 A 250VAC 50Hz: 1,0mA @ 20 A 250VAC 50Hz: 4,0mA • Hi-pot rating (1 minute) Line to ground ...
Voltage: 115, 250 V
Frequency: 50, 60 Hz
Electrical specifications •Rated voltage : 115/250 VAC • Power line frequency : 50/60 Hz • Climatic category : HPF 25/085/21 • Max. leakage current for standard version each line to ground
Frequency: 9.5 MHz - 77 MHz
Features • low insertion loss, 1.5 dB max. • good selectivity, 1.76 typ. 20 dB/3dB BW ratio • rugged shielded case Applications • high rejection applications • image rejection • IF signal processing
Mini-Circuits
Frequency: 950 MHz - 5,990 MHz
Features • Extremely wide passband, 950-2200 MHz • Small size 0805(2.0 x 1.25 mm ) • Temperature stable • LTCC construction Applications • Wireless communication • Harmonic Rejection • Transmitters / receivers
Mini-Circuits
Frequency: 950 MHz - 8,750 MHz
Features • Wideband, 950-1970 MHz • Low loss, 1.9 dB typ. • Small size, 1206 (3.2mm x 1.6mm) • Temperature stable • LTCC construction Applications • CATV/MOCA • Harmonic Rejection • Transmitters / receivers
Mini-Circuits
Voltage: 220 V - 500 V
Frequency: 60 Hz
... voltage drops through the system´s impedances. If voltage harmonics exceed 5%, or current harmonics exceed 20%, the tuning filters must be installed in order to avoid the premature wear out of capacitors. In such cases, ...
Current: 1 A - 1,600 A
Voltage: 1,140, 690, 440, 250 V
Frequency: 120 Hz
... the inverters output filter. An EMI filter, or electromagnetic interference filter, is an electronic passive device which is used in order to suppress conducted interference ...
A reliable product from Maxim which represents a wide range of anti-aliasing and post-DAC filters. This can be used in an easy and stable manner. Device that improves system performance for frequencies up to 300 kHz. ...
Frequency: 20 MHz - 150 MHz
Crystal Filter(MCF) is Band pass filter that can take out only a necessary frequency. The crystal high Q factor allow crystal filters to have steep band-pass ...
Murata Electronics
Current: 5 A
Voltage: 250 V
Open bushing mount Pi-filter, 2x1nF, 250Vdc, 5Amp 7mm long, M3,5x0,5mm thread. Ø0,6mm tinned copper wire.
Ferroperm
Frequency: 2.4, 1.6, 5 GHz
... available Band-pass filters, low-pass filters, balanced filters, balun, and diplexer/triplexer.
Yageo
The VLT Advanced Active Filter from Danfoss is made for places where many drive assemblies have to be managed. This will review a signal and will adjust it to make it more efficient in the event that there are problems ...
Danfoss VLT Drives
Frequency: 2,535 MHz
... performance Uplink BAW filter for LTE Band 7. This filter is housed in a compact 3x3 mm package for base station applications. Low insertion loss, coupled with high attenuation makes ...
Triquint Semiconductor
Frequency: 3 MHz - 150 MHz
DIL 3 - 150 MHz 0.001 to 1% (-45 to 90 °C) 2 - 8 dB 100 dB max.
Frequency: 2,400 MHz - 5,920 MHz
Characteristics Multilayer Chip Band-Pass Filter with low insertion loss and high attenuation SMD component in the sizes 0805 and 1008 Guaranteed filter characteristics ...
Current: 1.3 A - 60 A
Voltage: 400 V
Frequency: 60 Hz
General Data Rated voltage 3 x 400 Vac Rated current 1.3 ‑ 60 A for motor rated output 1.5 ‑ 30 kW for clock frequencies ≥8 kHz Rated frequency from 0 to 60 Hz Insulation class H Maximum ambient temperature 40 °C Degree ...
TDK offers a wide range of different line filters: common-mode chokes for power lines, differential-mode chokes and sine-wave chokes. Whereas the common-mode chokes are used to reduce the asymmetrical interference level ...
Please specify:
Help us improve:
remaining