{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Pressure: 0.5 bar - 20 bar
Flow: 10 m³/h
Orifice diameter: 0.125 in
... requirements of German Food and Feed (LFGB) Law, and is suitable for contact with food gases Features of the backpressure regulator Pilot Control Tube (PCT) One of the features enabling ...
Pressure: 0 psi - 400 psi
Orifice diameter: 1.27 mm
... crack open when pressures upstream reaches the set pressure (adjustable), allowing excess pressure to vent through the outlet port. When pressures drop slightly below the set pressure, ...
Pressure: 0 bar - 110 bar
Orifice diameter: 1 in
Temperature: -40 °C - 150 °C
... or FKM) Back pressure regulators are used in process pressure regulation to keep the pressure in a system constant. In this case, an excess medium, which would increase the system ...
Hornung GmbH
Pressure: 250 bar
... Min 10-3 mbar.l/s in Helium (valve / seat) External leak tight : Min 10-4 mbar.l/s in Helium Air flow by bar gauge of set pressure (connection in shunt of the process) and internal Ø 5 mm: - Ports 3/8" and 1/2" : 1,8 Nm3/h For a ...
IMF
Pressure: 10 bar
Orifice diameter: 0.5 in - 2 in
... covered by the guarantee) USE : • - Water distnbution • - Min Température Ts : + 5°C • - Max Température Ts :+65*C • - Max Pressure Ps : 10 bars ...
Pressure: 1.7 Pa - 2,100,000 Pa
Flow: 1,500 l/min
Orifice diameter: 0.25 in
... Pressure relief valve for protecting compressed air devices from overpressure. If the pressure setpoint is exceeded, overpressure is vented into the atmosphere until the setpoint is reached again. It is recommended to ...
the best suppliers