Cutting press lines
The need for cutting blanks adapted to the final shape of the part gives rise to the need for cutting them with a specific die. Fagor Arrasate is able to deliver a complete installation able to exceed ...
Force: 6,300 kN - 12,500 kN
Blanking lines equipped with servo-presses to manufacture shaped blanks are becoming the mainstream solution. Schuler’s ServoDirect Technology adapts the press’ slide motion to each die. This method ...
... full stack of heat exchanger plates at the end of the line. AP&Ts stable embossing presses with press forces from 3000 kN to 120,000 kN produce a high-quality pattern in the sheet metal. A coil line ...
... backed up by the most advanced control has been good trade-mark to the customers who adopted our blanking line with the accumulated technology. The line credits you with good reliability and economic ...
Your suggestions for improvement:
Receive updates on this section every two weeks.